Ganti ke : :: SITEMAPS

HOW TO ERECT AND SET THE FOLDING GATE

SINGLE GAT, KEY AT LEFT OR RIGHT AND NO SWING

KETENTUAN UMUM :

  1. Frame should be level, if not the folding gate will be difficult to open and close
  2. For anchorage welding should be to rebar concrete and using dyna bolt was not recommended
  3. Anchorage should be crossing each other
  4. Bottom anchorage minimum each 60 cm
  5. Upper anchorage minimum 3 places, depend on to the wide of folding gate

Urutan Pemasangan

  1. Placed the left and right pole, bottom rail and then upper farme
  2. Section (A) is temporary tag weld, the place to insert the folding gate in
  3. Release section (A)
  4. Insert folding gate through section (A)
  5. Weld back section (A) after the folding gate inserted in
  6. Key pole (C) install later after folding gte inserted ti door frame
  7. Set the key pole (C) with housing key (B) and then leveling and to pole (C) up and bottom
  8. Anchorage welded at pole (C) should be the same level with key pole (C)

 

 

HEAD OFFICE / WORKSHOP